L293D Motor Drive Shield For Arduino Duemilanove Mega UNO R3 AVR ATMEL

  • $6.44

    $6.85

  • Details Features:Module new and high quality.L293D is a monolithic integrated, high voltage, high current, 4-channel driver.Basically this means using this chip you can use DC motors and po..
    • Ex Tax:$6.44
    • Product Code: 20-011-914
    • Availability: In Stock

    Details

    Features:

    • Module new and high quality.
    • L293D is a monolithic integrated, high voltage, high current, 4-channel driver.
    • Basically this means using this chip you can use DC motors and power supplies of up to 10 Volts, thats some pretty big motors and the chip can supply a maximum current of 600mA per channel, the L293D chip is also whatrsquo;s known as a type of H-Bridge.
    • The H-Bridge is typically an electrical circuit that enables a voltage to be applied across a load in either direction to an output, e.g. motor.
    • 2 interface for 5V Servo connected to the Arduino's high-resolution dedicated timer - no jitter.
    • Can drive 4 DC motors or 2 stepper motors or 2 Servo.
    • Up to 4 bi-directional DC motors with individual 8-bit speed selection.
    • Up to 2 stepper motors (unipolar or bipolar) with single coil, double coil or interleaved stepping.
    • 4 H-Bridges: per bridge provides 0.6A (1.2A peak current) with thermal protection, can run motors on 4.5V to 10V DC.
    • Pull down resistors keep motors disabled during power-up.
    • reset button.
    • 2 external terminal power interface, for seperate logic/motor supplies.
    • Tested compatible for Arduino Mega, Diecimila amp; Duemilanove.
    • Size:6.8cm x 5.5cm x 2cm - 2.68inch x 2.17inch x 0.79inch.

    Package List:

    • 1x Motor Drive Shield L293D

    There are no reviews for this product.

    Write a review

    Note: HTML is not translated!
        Bad           Good